When we using the thermostatic taps, we should open and close it lightly, do not use too much force as too hard move off the valve stem may damage the spool. After using some time, the surface hanging of thermostatic taps is dirty, or because of the water contaminants may result in reduced flow or temperature control out of control, it is when requiring maintenance.
1. The leading surface linked to pollution: general wipe with a soft cotton cloth, as same as people clean the face. In order to maintain the leading surface brightness, we should always use ruanmian cloth with neutral detergent solution to scrub, rinse with water. It is better to clean thermostatic taps every two to three days, pay attention to the leading bogey bogey acid base surface.
2. The internal maintenance of thermostatic taps:
(1) Close the cold and hot water inlet valve of thermostatic taps.
(2) Use a wrench to unscrew the nut water faucet on both sides, remove the wire mesh gasket, check valve, clean the screen surface dirt, check valve of thermostatic taps is working properly, if not normal, to be replaced.